Cordless Drill Specs

* Not suitable for
use on concrete

* The maximum torque error is ±5Nm due to the
measurement device used. Torque test method:
With the battery fully charged, the function
selection button is pushed to enter screwing mode.
A torque tester is then used to test the locked-rotor
torque at level 30.
* Screwing test method: With the device fully
charged, the gearbox is adjusted to low speed
(screwing mode). In manual "M" mode, the tail
torque is adjusted to 10 and an M4 x 25mm self-
tapping screw is screwed into the pine board until
the battery runs out.
*Wooden board drilling test method: With the
device fully charged, the gearbox is adjusted to the
high-speed setting (drilling mode). In M mode, the
tail torque is adjusted to 30 and a 40mm-deep hole
is drilled into a white pine board with a 7mm wood
bit.
*The whole unit ROHS test report was issued by
EMTEK (Dongguan) Technology Co., Ltd.; Test
Report No.: ED201110010C.
*The environmental reliability test report was
issued by Intertek Shenzhen Ltd.; Test Report No
SZHH01513728.
The screwdriver bit test report was issued by the
National Light Industry Tool Hardware Quality
Supervision & Testing Station, Shanghai. Test
Report No.: G20201629F. Hardness varies by
±2HRC.
* The water-repellent fabric test was conducted by
Centre Testing International Co., Ltd. and is
waterproof up to class 4–5; Test Report No
A2210085110101C.
Security torx
Rated voltage
Hex
No-load drilling speed
Slotted
Y bit
Charging specifications
Tri-wing
Charging time
Square
Drill bit type
U bit
Extension rod

* No-load speed tolerance is
approximately 10%. Speed test
method: The fully charged device is
run for 2 minutes at no load and the
no-load speed is then tested with a
speed tester.

*Steel plate drilling test method: With
the device fully charged, the gearbox
is adjusted to the high-speed setting
(drilling mode). In M mode, the tail
torque is adjusted to 30 and a hole is
drilled into a 6mm-thick steel plate
with a 6mm twist drill.

*The whole unit compliance test
report was issued by Waltek Services
Test Group Ltd. in Foshan; Test Report
No.: WTF21F3015226G.

*The battery test report was issued by
Precise Testing & Certification
(Guangdong) Co., Ltd.; Test Report
No.: PTC20110204401S-GB01.

* Two extension rod designs are
available and will be shipped randomly.

30N·m

T9H/T10H/T15H/T20H/T25H

12V⎓

H3/H4/H5/H6

0–1400rpm (electric drill speed)

0–370rpm (screwing speed)

SL4/SL6

Y1

5V⎓3A; 9V⎓1.5A

2.3

120–180min

S0/S1

Metal twist drill bit 3/4/5/6

Wood drill bit 4/5/6/7

U2.6

60mm

Package contents

Electric drill x1
Storage pouch x1
Adaptor x1
Charging cable x1
Bit storage container x1
Drill bit x8
Screwdriving bit x24
Extension rod x1
User manual x1